runcorn2

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • May 18, 2014 at 11:40 am in reply to: hotpoint WF250G error code F10 #413534
    runcorn2
    Participant

    Re: hotpoint WF250G error code F10

    Thanks for help and advice, think its time for a new machine.

    May 17, 2014 at 12:24 am in reply to: hotpoint WF250G error code F10 #413532
    runcorn2
    Participant

    Re: hotpoint WF250G error code F10

    SORRY didn’t mean to shout, had left caps on by accident, I did read your other comments but still don’t understand why the pump runs when the PCB is disconnected (even if the pcb is faulty)

    May 16, 2014 at 6:52 pm in reply to: hotpoint WF250G error code F10 #413530
    runcorn2
    Participant

    Re: hotpoint WF250G error code F10

    IT MAY HAVE ISOLATED THE MAIN PCB BUT THE PUMP STILL STARTED AFTER ABOUT 2 MINUTES, SO WHAT IS TELLING THE PUMP TO START?

    May 16, 2014 at 5:19 pm in reply to: hotpoint WF250G error code F10 #413528
    runcorn2
    Participant

    Re: hotpoint WF250G error code F10

    I removed the 5 wire plug from the rear of the circuit board containing the on/off switch, isolating the switch and the other lights on the front panel .

    May 16, 2014 at 8:56 am in reply to: hotpoint WF250G error code F10 #413526
    runcorn2
    Participant

    F10 hotpoint update

    Re my post Sunday, with on/off switch disconnected but power switched on at socket the pump starts to run. Any help, suggestions would be appreciated.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)