[Rustyhill]

So I thought I would return with a quick update;

Last weekend I took apart the dishwasher to give everything a good clean. I found that the water draining pump was working but only just. It was all gunked up with what looked like old food and limescale (very hard water area here). Gave that a good clean along with removing the waste pipe and cleaning that too. Also increased the salt that is put into the washer during the cycle.

Put it all back together, and it now runs all cycles!
It would also turn out that 3 beeps must have been a error code, although I can’t find it mentioned in the manual. It now only makes 1 long beep at the end of the cycle. So I guess the quickwash was erroring out but as it had finished its single cycle everything was clean anyway.

Rusty

[Rustyhill]

So I have run the full cycle twice, both times it stopped after 20min ish, I could hear the rince cycle finish, sounded like the drain pump ran then the cycle stopped. 3 beeps, no other LEDs on other than the power one. The washing liquid draw did not open.
Straight after I ran the quick wash and it ran fine. The washing liquid draw did open in this cycle.

Any pointers on anytjibg to check or is it best just to strip it down and have a look at each bit?

Cheers for your help so far.

Rusty

[Rustyhill]

I’m fairly confident that the program is changing when the knob is moved as I’m getting different outcomes from the quick wash vs the rest of the programs.

There is no other indication of which program is running other than where the knob is pointed.

Rusty

[Rustyhill]

Hi Dave

Unfortunately they never registered it and they don’t have proof of purchase any more, my dad can’t even remember where it came from. (He is 90 and not totally with it Unfortunately)

Rusty

[Author]

Posts