[satcheee]

Re: Fisher and Paykel Gw708au error 43 but not oob switch ?

i tryed your temp up and spin to 7kg trick no good !

this machine is 7.5kg

so it washes rinses pumps out but when it comes to spin it revs up goes about a min then slowsdown then retrys sometimes on the next time it may spin other times it completes the 3 and starts to beep

i notice when i stick it on auto water level (AND THERES NO CLOTHES IN THERE) it fills to the top whilst checking along the way !!

[satcheee]

Re: Fisher and Paykel Gw708au error 43 but not oob switch ?

Penguin45 wrote:Tub bias spring is attached? If not the tub can move excessively and hit the lever. If yiur sure that the wiring is correct the fault probably lies in the motor controller board itself.

Penguin45.

hi penguin yes tub bias spring attached i have blown sensor tube as well

i just tryed another motor board and it shows a 1001000 code 9

error i tryed your temp up and spin to 7kg trick no good !

this machine is 7.5kg

so it washes rinses pumps out but when it comes to spin it revs up goes about a min then slowsdown then retrys sometimes on the next time it may spin other times it completes the 3 and starts to beep

i notice when i stick it on auto water level it fills to the top whilst checking along the way !!

you must have seen this problem before or someone must have

hope to hear from you soon
thanks

Lee

[Author]

Posts