[ShaunOverton]

Re: F&P Smartdrive GW701 – Error Code Help

bigsmokepiker wrote:Check pump for blockages
Also Check to see if Pump is Getting Hot

Drainage pump will no longer start. May have something to do with the sensor that detects water.

[ShaunOverton]

Re: F&P Smartdrive GW701 – Error Code Help

Hi there. Tested OOB switch – fine. Now I can’t get the drainage pump to work.

[ShaunOverton]

Re: F&P Smartdrive GW701 – Error Code Help

Thanks for joining “bigsmokerpiker”. Have checked for leaking, none that I can see. The results from my testing is included in the first post. The OOB switch seems to be working but I will test anyway to be sure.

[ShaunOverton]

Re: F&P Smartdrive GW701 – Error Code Help

Thanks for your help “Penguin45”. The out of balance switch and lid open switch are fine. The inlet valves are starting then stopping – maybe I wil have to get a new main-board?

[ShaunOverton]

Re: F&P Smartdrive GW701 – Error Code Help

Penguin45 wrote:What has the pump got to do with the inlet valves? The touch panel/ control board is the Display Module.

Penguin45.

Sorry about confusion. Drainage pump and inlet valves are fine. Machine has problems providing a “stable” voltage to the inlet valves when operating machine normally. But when you goto diagnostics, both inlet valves are fine. So, why won’t the machine operate normally?

[ShaunOverton]

Re: F&P Smartdrive GW701 – Error Code Help

Penguin45 wrote:Error code is 00100001 = 33, which is a water valve fault. Can be faulty wiring and connectors. Possible solenoid coil failure (should read 15 ohms). If all OK, it will be a fault in the display module.

Regards,
Penguin45.

Sorry, but what do you mean by display module? The machine has a main-board and a control panel with Leds? The problem is i cannot get to do a normal cycle. It always has problems when it starts to fill. I did a multimeter test and the power/current is fluxuating. The pumps work in diagnostics and from a external power source.

[Author]

Posts