Forum Replies Created
-
Posts
-
Re: Hotpoint WDD960 F15 error with Flashing LED’s
Well how stupid do I feel? A lesson to anyone reading this check the basics first!!!!! I went all out with the error code and bought a replacement module….spent time removing old one and installing new one…..during which I had a wiring crisis that I had to get round after pulling cables out of a connector……
I just went to check the resistance of the element and only then did I notice the broken cable on one of the terminals…..
This is the simplest job to fix that will take only minutes……temporarily attached cable and the machine spins with no error codes……
Hmmmm what a plonked Rodney!!!!
Re: Hotpoint WDD960 F15 error with Flashing LED’s
OK thanks for that. If I meter out the dryer heater coil what result should I expect?
Re: hot point aqualtis 1400spin
I think F05 relates to the pressure switch. Google that and you’ll find how to do some simple steps to check it out.
There are some good video tutorials out there. Espares are a good bunch to look up.
Good luck
Re: Hotpoint WDd960 wiring help
Quick update.
The F15 code comes up and all 5 led’s are flashing rapidly and so is the led on the start/pause button.
If I put the machine on a spin only cycle it stops with the above error code shortly (within a few seconds) after pumpin out. If I put it on a long hot wash it will wash for about an hour before stopping with the same error.
Searching the net suggests the error relates to the heater relay (which I was lead to believe
Is on the main pcb, hence why I changed it). I have however not found an exact match for the error code and lit LED’s combination,Anyone seen this before?
Re: Hotpoint WDd960 wiring help
Thanks, you were spot on. Got nachine powered back up.
Bad news is even with the new control module I still get the F15 error code!!!
A lot of work to get nowhere fast.
Anyone got any suggestions on what to check next? Before buying the replacement board I had the pressure switch out and blowing into it I get a reassuring click so that seems to be working.
Any help appreciated.
Thanks
