[Southside691]

[USER=”4209″]electrofix[/USER] I tried the rinse and spin and that worked fine, water was being pumped out nicely. The filter I had cleaned even before I came here and I also checked the propeller was moving freely. I did open up the rubber drain piping from underneath to check for any obstructions which I didn’t find any of but I noticed a plastic ball in there near where the drain pipe connects to the drum. I’ve read that this is by design but I feel I should remove it? Also, heating the water is not happening. Is that a simple fix by replacing the water heater?

Thanks again for the advice

[Author]

Posts