Forum Replies Created
-
Posts
-
Re: Hotpoint WMA63 Bearings?
HI, Have you tried looking through the holes in the drum with a torch to see if there is anything stuck around the element area? Six o clock postion. Bra wire sounds the most likely.
Re: Problem on a Hotpoint WD420 Aquarius washer/dryer
Sorry to say that fault is a SETUP ERROR on the eeprom contained on the module. They can only be reprogrammed by the manufactures service team or you can replace the board and eeprom together.
Re: Cant Reset my washing Machine – Beko W1715s?
Hi There.
Sounds like you have got the machine into its test mode.My info says to exit the test mode all you have to do is switch off the machine.
You need to read the lights in the programme follower to work out the fault.
Follow the procedure you have been given ie Turn dial to 90 then Power on holding start/pause/cancel. Turn dial to spin position. Press start/pause once more. Look at the programme follower leds. From top to bottom are they on or off. This will give you a binary code 1 for on and 0 for off. Tell me what you get….
CheersRe: Problem on a Hotpoint WD420 Aquarius washer/dryer
Hi. I need a little more information but the flashing lights are a fault code.
Can you tell me the location of your flashing lights? Are they four in a horizontal row or five in a vertical row?CheersRe: Indesit WIE 127 – Fault Code F12
HI.
F12 is a comunication error between the main module in the back of the washer and the LCD module behind the control panel.
Check the connections on both boards by removing then refitting the connectors.
If you are very lucky it will just be a bad connection.
Cheers
