[spidersmith]

Re: Diplomat ADP8322 Dishwasher Problem

Ok thanks for the help everyone.

I’ll get in contact with MFI and let them sort the problem.

Cheers

[spidersmith]

Re: Diplomat ADP8322 Dishwasher Problem

DentedPorsche wrote:The spigot is under the sink, where you plugged the drain hose into. Newer types have a hole but are plugged inside. Check that it’s either unplugged or opened.

I did not use the spigot for the drain hose. The drain hose has its own waste pipe out of the house.

I’ve tried pulling out the machine from the fitted units to ensure the water supply and drain hose are unhindered but this has made no difference.

The same problem occurs but I have noticed that just before the machine stops and the error beep starts that the sound of the water and the motor within the machine begins to stop and start in surges that quickly decrees in duration until the error beep begins.

[spidersmith]

Re: Diplomat ADP8322 Dishwasher Problem

Thanks for the reply.

The water is defiantly turned on as when I open the machine after the failed wash cycle the inside of the machine is wet.

What is a “spigot”? And where might it be located on the machine?

I will now make sure that the water supply and waste pipes have no kinks.

Thanks again

[spidersmith]

Re: diplomat adp8322 integrated dishwasher problem

Hi all,

I have just installed my ADP8322 and I am experiencing the following problem: about 10 minutes into any wash program the machine starts to beep. The Start light is flashing to the following code: FLASH-FLASH-PAUSE repeat…

Does anyone know if this corresponds to a simple problem that I can rectify or should I call MFI and have the machine repaired/replaced?

Any help would be much appreciated.

[Author]

Posts