[Splashcam]

Re: F&P 701 washer fault code 17

Thanks Penguin,

When going into Diagnostic (as per your Sticky above) I don’t get “2 beeps” but pattern of LEDS seems to change correctly.
Restart then seems to turn on/off OK.
With Restart OFF (confirmed by 5 LHS LEDs showing) I get Fault 9 ( = size problem)

So I try to set size:
I turn Restart back ON (either via diagnostic or Mains OFF for 10secs) to get zero LEDs at Mains ON. Then hold TEMP UP as hit POWER – but this does not give expected 4 beeps and LEDS do not change from “Ready to Wash” pattern – so I can’t set size (for 7.5kg = SPIN SPEED UP to light SPIN HOLD, then press POWER to lock in size . I don’t have “Tech Instructions” for this machine – is this the correct procedure for trying to set size? If so, any ideas on what’s going wrong?

If i try to Start wash i still get LED 1 flash & beep & no action.
I’m concerned that as I still don’t know cause of original board frying I risk blowing the new one.

all the best, Splashcam.

[Author]

Posts