Forum Replies Created
-
Posts
-
Hi Dave thanks for your support. Really appreciate. Do you think i can keep running thd machine with the gest mode trick or it’d going to break it?
anyway i checked on line and all ghe stores have my pcb out of stock.Stefano
There are two note on the pcb, one says what i wrote before. And the other shows this: 2437301080
There is a 0 instead a 1 at the end.!!??Hi David
thanks for your time, here you have the codes:Machine:
Commercial Code 7161541500
Model Beko Wdr7543121w
S/N 18-402867-03New PCB
S/N 3319003813
Rev: g09-b03-t01-d01
Y/N Terma_FTC_07hopefully it can help for clarifying the issue. Is there a way to reconfigure the board?
Thanks a lot
Hi Dave, i did the same things the lady did in the post. I changed the PCB board as suddenly the machine stopped working completely. After changing it the machine came back alive but i couldn’t wash because the door doesn’t lock. I entered in test mode and appears E23 error, which i suppose is exactly the door lock code error. I checkked the wiring and i changed the lock. Nothing it doesn’t work. The only way to let the machine starting the cycle and wash my laundry is to enter in test mode that manages to lock the door, than turn it of and on again. In this way the door is still locked and I can start washing.
It is strange what it does because the lock works in test mode and the machine works fine with the trick i am using. I think it is just the case to reset the machin/board.
do you have any ideas?Thanks
