steliz

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • in reply to: Hotpoint BWM129 mysterious water fill #333618
    steliz
    Participant

    Re: Hotpoint BWM129 mysterious water fill

    OK, thanks for that.

    I think the problem must be the outlet pipe because it connects to the sink drain and flows slightly up to the ubend before going through the wall to the outside drain.

    Had this set up for almost 3 years and never had this problem before though.

    I will try to lift the w/m drain hose higher.

    in reply to: Hotpoint leak #273353
    steliz
    Participant

    Re: Hotpoint leak

    Hi Jim,

    thanks for the info.
    I have checked the filter already and it was clear.
    My wife does tend to put too much detergent in so I will make sure the drawer is clean and cut down on the soap and see how things go.

    Thanks

    in reply to: Whirlpool temperature problem #217895
    steliz
    Participant

    Whirlpool problem

    Hi,

    I still have the same FF and the cure for the recurring problem is to simply defrost. No new parts or expense necessary.

    I now have another problem, the FF started making a loud clicking noise which I traced to the lower right corner where there is a plastic box with a small viewing panel. Inside is a circuit board. I can get the clicking to stop by opening and closing the fridge door but it starts again when I open the freezer door. Also there is no power to the control panel. Apart from that it is working normally.

    Thanks in advance

    in reply to: Whirlpool temperature problem #217891
    steliz
    Participant

    Re: Whirlpool temperature problem

    Hi,

    It’s one year later and I’m having the same problem again.
    No error codes but the same hot weather.
    Is there anything I can do to unstick the damper?

    hanks

    in reply to: Whirlpool temperature problem #217890
    steliz
    Participant

    Re: Whirlpool temperature problem

    Ok, thanks for that, the problem seems to have rectified itself now as all is well.
    I didn’t get an error code. Do you know why the damper would freeze and can I get to it if it happens again?

    Steliz

Viewing 5 posts - 1 through 5 (of 5 total)