[steve1832]

Dave – I got the lock out and fitted a new one. After reassembly all was well the machine worked as it should, so a great result ! However, it only ran for one complete wash and then it failed again. The fault appears to be the same (error code E42) and there is a clicking sounds as the door tries to release. Is there some other fault that would cause the lock to fail?
Thanks in advance.
Steve

[steve1832]

Dave, Thanks for the additional advice – it worked and I have got the lock out.

Steve

[steve1832]

Thank you for the reply – I have tried pushing the dimples in as you suggest but there is plastic around where the door pin (latch?) goes into the body of the machine and this seems to be attached to the inside of the door mechanism. Even though I can push the dimples in the lock doesn’t seem to move. I tried to up load a photo of the plastic surround but I get an error about quite space.

Thanks again in advance.

Steve

[Author]

Posts