steveb21

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
January 28, 2023 at 9:21 am in reply to: Bosch Washing machine not running program after tripping RCD #485573

steveb21
Participant

https://photos.app.goo.gl/y2CH7UAqma3gdcDp6

the area where the damage is appears to be coming from the 3 pin type connector with the grey wires. I will chase back to see which component it is connected to.

January 27, 2023 at 9:05 pm in reply to: Bosch Washing machine not running program after tripping RCD #485571

steveb21
Participant

You were right, something has blown as there is a clear visible burn mark on the white plastic (near the round dial area).
Two PCBs.
1. Large PCB where i can see a burn mark on the board
2. User input PCB which controls the buttons on the front face

Is it a simple case of replacing the board with a like for like?
I took photos however the site will not let me upload as my upload limit is too low.

January 27, 2023 at 8:07 pm in reply to: Bosch Washing machine not running program after tripping RCD #485570

steveb21
Participant

Just stripping it down, have a screw thats seized up. Will report back once i get to view the PCB.

Thank you.

January 27, 2023 at 7:22 pm in reply to: Bosch Washing machine not running program after tripping RCD #485568

steveb21
Participant

electrofix wrote:think i would be removing the pcb and looking for damage

Dave

Hi Dave
Is this the PCB user interface board? Are you aware how many PCBs there are on this machine?
Thanks
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)