[steve@oxted]

Re: Dyson DC08

Assuming fuse is ok, have you tested continuity for both phase & neutral on the supply lead? I had a similar problem with a DC05 and it turned out to be the neutral within the moulded plug. My switch was wired in to the neutral which delayed me identifying the fault as I was registering voltage at the motor and assumed continuity (never assume eh!)

Hope this helps
Steve

[steve@oxted]

Re: Dyson DC05 – Switch

That’s my weekend job sorted then.
Many thanks
Steve

[steve@oxted]

Re: Dyson DC05 – Switch

The DC05 has only a single screw which after removing does not obviously show what has been released?
As far as safety reasons are concerned, I am a qualified electrician so could you email me privately with some dismantling tips?
Thanks
Steve

[Author]

Posts