[steveshaw]

Re: Hotpoint CTD80 dryer Drum support bearing replacement

To all, Many thanks for the advice. The new parts are installed and the dryer runs like a dream…. for now!

[steveshaw]

Re: Hotpoint CTD80 dryer Drum support bearing replacement

Thanks to all, much appreciated. New parts arive today, I will post to let you know how it goes.

[steveshaw]

Re: Hotpoint CTD80 dryer Drum support bearing replacement

Thanks helo_75, I have already had the machine fully stripped down due to an F-08 fault for full access to the PCB, thats how I found the problem. Forgive my ignorance, but after installation does the front of the drum locate into the four bearings? as such are the belt and Rear bearing superfluous

[steveshaw]

Re: Hotpoint CTD80 dryer Drum support bearing replacement

Thanks for the reply’s. The brass bearing I refer to is the press in brass bush within the plastic drum support roller. At some point, either during manufacture or subsequent use the insert has deformed causing the drum to ‘chatter’ during operation as the roller is no longer concentric. I assume each of the two existing rollers are to be removed when the new parts are installed, what I would like to know is where each of the four ‘bearings are to be installed and where the belt is supposed to run

[Author]

Posts