[stuandsal]

Re: Zanussi washine machine problem

Have tried slamming the door a few times. This didn’t work but I understand the logic. There are two screws on the front next to the catch. Do I remove these to get to the switch. Don’t worry, I will isolate the power first!

Re. the pump/ motor. May these be suspect because the machine didn’t fully pump out on it’s last use? Anyway, I don’t know how to take the machine apart but will if I have to.

Thanks for your replies so far.

stu

[stuandsal]

Re: Zanussi washine machine problem

To do this, I selected a cycle and then removed all parts of the cycle apart from the spin and then pressed go and nothing happened. By the way, the door locked light was on throughout.

stu

[stuandsal]

Re: Zanussi washine machine problem

A bit of extra info. The door locked light does not come on until I select a washing cycle. This is a correction from my first post.

[stuandsal]

Re: Hotpoint DWF30 problem

Thanks for the reply. I don’t feel stupid at all!

Will tell you how I get on.

ta

stu

[stuandsal]

Re: Hotpoint DWF30 problem

When you say, the plug, what do you mean? The waste pipe?

I currently have the dishwasher on test in the middle of the kitchen on a couple of pieces of wood to raise it off the ground.

ta

stu

[Author]

Posts