stvlada

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: Siemens SE35M563SK no enough water #467863
    stvlada
    Participant

    Thank you Dave. Do you have any tips or recommendation what to do next? I believe this could be cleaned? If yes, what are the steps to disassemble this? Is there any service manual that could help me to do step by step?

    Maybe you can describe what/how to do this service?

    in reply to: Siemens SE35M563SK no enough water #467861
    stvlada
    Participant

    Dave, may I ask you to go through some of the videos I made today. There is something I don’t understand as I’m not a subject matter expert.
    I’ve recorded videos with the whole process, almost the whole 40min program, where you can see different steps and how the valves reacts.

    can you see something that doesn’t look normal? I haven’t been able to check the coils as my multimeter didn’t work. I’ll have to get a new one first.
    I’ve uploaded all videos yo youtube channel.

    https://www.youtube.com/playlist?list=PLUAtmU6v2Ulckihncy8eMYMr-qOgQ28tp

    Thank you in advance!

    in reply to: Siemens SE35M563SK no enough water #467859
    stvlada
    Participant

    So, I tried that…
    First, machine spins like emptying the current water. After that, it starts filling in the reservoir. When water reach the top level, then it overflowed into the small chamber and blue hinge moves. I didn’t took enough attention on the red float. I’ll take a closer look again tomorrow.
    After that water level from the reservoir sinks down looks like it get stuck there, and after I manually add some water machine starts the full cycle with spinning both arms, bottom and top. Temperature goes up, all ok. After a while, looks like first cycle is over, and machine tries to empty water. On the next cycle of filling in the water, scenario above repeats. Once second cycle is over, machine finish the program and the tank remained full of water.

    On below video is the level of water in the tank after I added some water manually. Before that, level was slightly lower.
    http://www.profystudio.com/dishwasher/siemens.mp4

    in reply to: Siemens SE35M563SK no enough water #467857
    stvlada
    Participant

    Dave, thanks for the prompt feedback! This looks familiar, based on the attached pictures.
    Is there anyway you can share that manual with me as I would like to learn more about the whole assembly. This looks somehow complicated to disassemble to clean up.

    http://www.profystudio.com/dishwasher/IMG_5436.JPG
    http://www.profystudio.com/dishwasher/IMG_5437.JPG

Viewing 4 posts - 1 through 4 (of 4 total)