Forum Replies Created
-
Posts
-
Re: Bosch Logixx SGS66A02/GB20 low water level
When the motor cuts in no more water enters the machine?
Re: Bosch Logixx SGS66A02/GB20 low water level
The water only fills the well where the filter sits. Nowhere near the salt cap.
Re: Bosch Logixx SGS66A02/GB20 low water level
The dump valve is opening, if I disconnect the dump valve water stays in the matrix when i reconnect water flows out. Just not enough water!
Re: Bosch Logixx SGS66A02/GB20 low water level
Checked all hoses no blockages, water fills once only motor cuts in no more water ! What I have noticed the blue arm on microswitch does not move even when it fills up! This machine is doing my head in!!!!
Re: Bosch Logixx SGS66A02/GB20 low water level
That hose is clear. It only fills the matrix once. No more fills! Is it a timed fill on these machines?
Re: Bosch Logixx SGS66A02/GB20 low water level
Is it the white ribbed hose? If it is I already cleaned that out will check again monday.
Re: HOTPOINT FDW80
I can tell you part number was C00115902 will let you know the serial number tomorrow.
Re: HOTPOINT FDW80
The motor fitted looks exactly the same as the one taken out. Motor runs free not tight. Any other suggestions?
Re: WHIRLPOOL DISHWASHER ADG4952M F4 FAULT
Checked pump all ok selected any program no fill for a few mins then F4 fault?? In the test mode it fills then heats then after heated F4 fault flashes. The fault guide say F4 is drain pump,control board OWI (what is OWI ?) or water indicator defect (What is water indicator defect?). Any help anyone James.
Re: NEFF R4381X1GB/01 condenser tumble dryer no heat?
Have checked with full wet load in. Still no heat! Checked heater thats all ok. Anyone? 🙁
Re: ZANUSSI ZWD1681W
Spin cycle is ok. (Induction motor) I was hoping for a simple test program any ideas ? I will check other parts tomorrow at the customers house.
