TasMan

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: Diplomat ADP 8352 flooding – long story..! #292171
    TasMan
    Participant

    Re: Diplomat ADP 8352 flooding – long story..!

    Well it seems this dishwasher is a goner…

    I am told it could also be a motor failure with water leaking out through the motor seals, and have been quoted up to around £150 for repairs so its getting binned.

    Howdens (where I got the kitchen from) have offered me a Beko slimline dishwasher as a replacement, no idea what model and whether Beko any good, £199 +VAT.

    Any horror stories about Beko dishwashers ? Guess you pay your money and take your chance !

    Only thought is whether anyone has any comments on using powder compared to tablets and whather this has an impact on the life of these small budget dishwashers ?
    Cheers
    David

    in reply to: Diplomat ADP 8352 flooding – long story..! #292169
    TasMan
    Participant

    Re: Diplomat ADP 8352 flooding – long story..!

    Meant to add I am in Glasgow if this is terminal and anyone can offer suggestions for an engineer

    Thanks
    Dave

    in reply to: Hoover 1300 Special Edition PE235 drain pump siezed ? #218550
    TasMan
    Participant

    Re: Hoover 1300 Special Edition PE235 drain pump siezed ?

    Thanks again,

    The machine is just over 5 years old unfortunately so probably not covered now.

    I could change the board and pump myself but verging on easier buying new machine I should imagine ?

    Thanks
    David

    in reply to: Hoover 1300 Special Edition PE235 drain pump siezed ? #218548
    TasMan
    Participant

    Re: Hoover 1300 Special Edition PE235 drain pump siezed ?

    Thanks for the quick reply.

    Since my post I have stripped out the pump and the impeller is definitely binding but there are no objects jamming it. I would have thought such a pump would be free to turn over at all times ?

    The pump appears to have slight surface rust but nothing suggesting a heavy leak from above.

    I did notice two other things:-
    Drum spring binding on drain hose

    Burning at PCB next to programmer (no evidence of water)

    Does this mean a new control board also ?! 🙁

    Thanks
    Dave

Viewing 4 posts - 1 through 4 (of 4 total)