[TheGatherer]

Re: Hotpoint Ultima WMA74 door issue

Hi Martin
The old seal wasn’t leaking through holes it just wasnt fitting well to the door and was leaking out the bottom. I was trying a new seal before looking at the hinge as a next step if needed. The PCB is ok but like you say maybe one of the wires is damaged. I will try a new interlock as that is fairly cheap then get someone to check the wires if need be after, thanks

[TheGatherer]

Re: Hotpoint Ultima WMA74 door issue

Took the top off and checked but all wires seem still firmly in place.

Any suggestions before I call out an engineer? Is it worth me ordering a new interlock and waiting the few days for it to come or is this likely to be a waste of time?

[TheGatherer]

Re: Hotpoint Ultima WMA74 door issue

Thanks for the reply Martin. I took off the seal again and the interlock looks fine with the plug still on. Leaving it tonight then I will take the machine out to get the cover off and see if any plug or wire has been dislodged from the panel but not holding out much hope.

[Author]

Posts