[tomarse]

Re: Hotpoint Aquarious 1100 not watering the soap tray

Thanks Mr P! I wondered how long i could lurk on your forum before you found me! 🙂

I’ve actually tidied the workshop a bit now and its almost a ‘utility room’ again 😉

I will do as you say and have a go at the filter. The machine is on little 90degree cut off taps so perhaps it is the hot one of them that has clogged.

[tomarse]

Re: Hotpoint Aquarious 1100 not watering the soap tray

Martin wrote:Probably the hot water valve has failed? Have you turned the water off and checked to see if the inlet filters are clear? What is the model number of your machine?

Sorry about the model number. didnt realise it wasnt just the obvious one.

WM63P it says inside the door.

any idea how i check the inlet filters?. I assume i have to pull it out and remove the lid? (or is there a cover on the back or something?)

Despite not running water through the tray it still fills up and washes stuff. Do you mean that it could only be running on cold water right now – should the powder tray get run through by hot?
Come to think of it, I did notice that it seemed to take a long time to do my last load which I assume could be because it used cold water and had to heat it?

[Author]

Posts