[tomaszm]

Thank you again.
I have taken out the pump and tried it on mains – unfotunatelly it worked. So i have taken out the eeprom and I found a place with a little burn , so I guess a part of it is foulty now , the part that is responsible for the pump to work properely. Well I fell we are going to get a new machine. Without he dryer this time – as dryer still works in the old one.
Thank you a lot – it was great help.
All the best
Tomasz Madajczak

[tomaszm]

The news are – the pump doesnt work while it is spinning. Does it prove that it is the pump ?

[tomaszm]

Thank you – I will check that imediately.

[tomaszm]

just one more question : what the eeprom setup is ?

[tomaszm]

Thank you again
That give me more hope again. In what I dont know yet. I checked the filter – it is fine, I kind of checked the presure swith and pipe , and (if it is possible to judge) it seems fine, no blockage. Is there a way to try if the pump is foulty. If I take pump out and connect it to 220v – would I kill it – or might it give me some idea about its performance. Any hope ???

[tomaszm]

Thank you all.
The motor is fine. The machine works on spinning and rinsing programme , so the motor goes fine, but whenever it comes to pump out the water the machine stops and the leds starts flashing. So if I count them from left to right it is the 2 & 4 which are green and than the 5 red. Any more sugestions ???

[Author]

Posts