tony-tech

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: Hoover HW6316M #393998
    tony-tech
    Participant

    Re: Hoover HW6316M

    Andy – You are perfectly correct it is a washer/dryer. The washer is operating perfectly, so much so its a pity not get the complete cycle of drying etc. The machine is pristine and hardly a sign of wear. I am begining to test out control PCBs and check voltages sinces it is making an attempt to start drying but shuts off after a few seconds in cycles. No clues yet.

    in reply to: Hoover HW6316M #393996
    tony-tech
    Participant

    Re: Hoover HW6316M

    Thanks for suggestion. Been looking for web sites with diagram but apart from user’s instructions put out on the Hoover-site unable to locate an electrical schematic, not even within the machine. My area of expertise was Maytag and models used offshore on rigs and maritime where I was a tech. Been retired for a dozen years or so but like to keep my hand in. Thanks for responding. Good to know helpful persons around. Ps. My area of speciality was self propelled jack up barges, laundry included – Tony

Viewing 2 posts - 1 through 2 (of 2 total)