[twingy]

Re: Bosch filling/emptying constantly

Took the side covers off. At switch on the dishwasher began to empty. After a few seconds the water input opened and started to fill the machine via the air break. But the pressure switch never operated as it kept emptying.

I checked the red float (presumably part of the flood protection system) but it didn’t move and didn’t actuate the microswitch.

Pressing reset stopped the inflow of water but it kept on draining.

I then did a diagnostic reset (holding normal and eco buttons while switching on). It then ran through a normal cycle finishing in just over 90mins. I ran it through the quick programme and it finished OK in 25mins.

So it looks as if it could be an intermittent problem (perhaps a faulty cable in the bottom of the door) or perhaps the controller has a problem which the reset cleared or something else.

For the moment it looks OK so thanks for your help

Huw

[twingy]

Re: Bosch filling/emptying constantly

Thanks Dave

I’ve attached a photo of the left hand side. To the left of the red float there appears to be yellow deposits. Is this the softener or gunge?

I suppose to remove this unit to clean, the matrix will have to be detached.

The machine was heating on the lengthy programme

[Author]

Posts