[URL]

Re: Beko DSFS 6831 spinning arm replaced, still not spinning

thank you for everything Dave!
It works now! 😀

[URL]

Re: Beko DSFS 6831 spinning arm replaced, still not spinning

I have just replaced the 3W valve, the arm is spinning properly now!
however, the test cycle did not drain the water.
is there a setting to manually start the drain cycle?

[URL]

Re: Beko DSFS 6831 spinning arm replaced, still not spinning

electrofix wrote:you would have to check for power going to the motor and if it was not turning then replace it

you could remove it and power it up off the machine and see if it turns but don’t forget to take care with mains electricity

Dave

Looking at the 3w valve, it looks like the hole is not perfectly aligned (see attachment)
Is it supposed to be like this or should I try to fix it?
is it worth try fixing it or is it better to buy a new one?

[URL]

Re: Beko DSFS 6831 spinning arm replaced, still not spinning

thank you Dave!
your help is much appreciated.
I’ll check in a couple of days

[URL]

Re: Beko DSFS 6831 spinning arm replaced, still not spinning

is there a way to check if it’s the valve faulty or if it’s the timer?
I read that I can test the valve for electrical continuity and I’ll check it this weekend.
—
I would like to avoid buying a spare part that I actually don’t need (it’s not that cheap)

[URL]

Re: Beko DSFS 6831 spinning arm replaced, still not spinning

thanks for the prompt answer

I’m trying to find a manual or a post that can help me out in:
-understanding what the 3w valve is and where it’s located
-since it’s position error…can it be fixed without replacing it?

[Author]

Posts