Forum Replies Created
-
Posts
-
kwatt wrote:Chinese I’d expect, not recommended but a model number would help offer more information.
K.
FROM THEIR SITE
Name:
Diplomat
SKU:
ACA9102
General Description
* • Half load button • Low salt and rinse aid indictors • 2-6 hour time delay • Anti over-flow device • Cold fill • 6 programmes: • Pre wash • Rapid – 40°C • Delicate – 50°C • Normal wash – 55°C • Glasses – 55°C • Intensive – 65°C
Price:
£329.00obviously the mrs values the integrated look more than anything – i’d prefer it not to blow up…
i can get an intergrated replacement from mfi for £329 – any guesses as to whose behind these latest models?
Re: adp 8902 problems
it’s now died. started normal wash . all was good then sounded like and arcing noise then dead. fuse is ok but no lights and no noise. rip diplomat. anyone recommend a cheap but reliable slimline dishwasher? thanks
it seems that the machine continues to fill and that the pressure switch if activated during this process does nothing. can anyone tell me how to test the switch with a multimeter please? thanks
had the door seal off and back on. i doesn’t leak until the thing gets part way through the soak program i think it’s all related to overfilling – whats the part i need to replace that senses the fill level? float switch appears ok – no water in it. thanks
it seems it’s sprung another leak – water trickles out at the edge of the machine in operation by the time i’ve drained and turned on it’s side i cannot tell where it’s leaking from. most annoying
Re: adp 8902 problems
kwatt wrote:That’s because we get asked about it loads of times. 😉
K.
i can imagine. i removed the side fill it was leaking by o rings cleaned out with hose. machine fills and no leaks. however i can’t locate this pipe with flap at the end the link mentions. that might be the problem?
thanks and sorryRe: adp 8902 problems
kwatt wrote:That’s because we get asked about it loads of times. 😉
K.
i can imagine. i removed the side fill it was leaking by o rings cleaned out with hose. machine fills and no leaks. however i can’t locate this pipe with flap at the end the link mentions. that might be the problem?
thanks and sorryRe: adp 8902 problems
had a search for “e2 error diplomat” looked a lots of results couldn’t find it – can you suggest better search term please? thanks
Re: adp 8902 problems
i can’t get it to reset properly. reset results in 1 on 5 flashing every time. it then starts and runs through some process if i let it.
thanksRe: adp 8902 problems
Still got the same problems same sequence of lights. can’t seem to get it out of this mode.
