Forum Replies Created
-
Posts
-
Re: GW10US Cycle Stops at each spin step
Turned out it was a leaky water pump.
Not exactly sure how the pump affected the cycling, but the old pump was leaking and after installing a new pump it works fine.
Sometimes you just need to call in a pro.
Re: GW10US Cycle Stops at each spin step
My apologies.
Re: the codes in my first message — While holding “Temp Down” I pressed Power per the instruction sheet inside the washer control panel.
The codes correspond to stepping through the various spin lights where “Hold” = 1, “Slow” = 2, “Med” = 4, “High” = 8, All = 15, etc.
Following the sticky, (I don’t see a GW10US listed in it) I tried it both ways (with and without pressing Advance) — either way, after the short two beeps when the Hold and Slow spin lights are lit, none of the cycle lights are lit at all. But the “Softener Rinse” and “Water Level Low” are both lit.
Sorry to be difficult. Thank you for your help.
