Forum Replies Created
-
Posts
-
Re: Hotpoint WF220P control board cable positions
Thanks for your help guys.
An expensive lesson learnt !!!!
😡
Re: Hotpoint WF220P control board cable positions
Board cost £118, with no mention of programming!
Sounds like it would be as cheap to buy a new machine?
Do all boards require programming.
Surely they could make them plug and play?
Thanks for your help in this.
Re: Hotpoint WF220P control board cable positions
Purchased from Espares.
No I was not aware that the board needs to be programmed.
I assume I have to get someone in to carry this out?
Re: Hotpoint WF220P control board cable positions
It was a new board, however I have just noticed that the old board does not have a connection J5, however the new board does.
Have I got the wrong board or has the board been updated?
Machine stopped working just before the end of it’s cycle. The old board was checked and a number of components are burnt / blackened.
Re: Hotpoint WF220P control board cable positions
Many thanks for the information, but now the lights flash on the front of the unit. This was not happening before the pcb was replaced.
The on/off light flashes and there are 4 lights on constantly next to the powder draw.
Where can I find the information on error codes for this machine?
Re: Hotpoint WF220P control board cable positions
I’m not after any wiring diagrams or schematics, I just need a picture showing the relavent positions.
The 2 connections that could take these 2 cables are either J3 position 5 & 6 or J4 position 4 & 5.
Many thanks again.
😕
Re: Hotpoint WF220P control board cable positions
I am a domestic electrician, does this allow me trade access?
I can supply an email address if that helps?
alex@aclectrics.co.ukRe: Whirlpool double oven element
I have found the model number under a pile of grease.
AKP950 1X
857795015010Can you let me know the element I require for thew lower fan oven?
Thanks for all your help.
RegardsACLectrics
Re: Whirlpool double oven element
I have a picture of the oven and control panel, where can I send it?
Re: Whirlpool double oven element
Should this be 4812 259 98405 and not 4812 259 98465 ?
ACLectrics
8)Re: Whirlpool double oven element
It is a built under double oven, stainless steel in colour.
Will try and get pictures shortly, however I have looked all over the oven inside and out, and there are no labels for model number or service number.
The element has 3 electrical connections to it.
Did Whirlpool fit a 1500W element?
Many thanks for your help.
ACLectrics
8)
