Forum Replies Created
-
Posts
-
Re: hotpoint WD420 final spin fault
No lights flashing, just final spin light on and door locked light on. Pump motor runs for a minute then final spin light goes off.
Cheers for quick reply
Andy
Re: hotpoint WD420G won’t start!
Relax! Took motor back off and I had managed to pull one of the brush connectors off when I fitted the motor. All works fine now!
Re: hotpoint WD420G won’t start!
Right. The motor brushes were really worn, so I have just changed them as the problem seemed to sort itself for a while(after banging the washer off the floor!) but has re-appeared.
Now the wash light comes on when a program is selected and the door locked light is flashing. The wash program will not start.thanks in advance
Andy
Re: Hotpoint wd420G flashing lights
Had a look through forum and it is an f13 fault. Took the top off and one of the wires from the sensor on top of the heater unit had broken. Soldered it up + insulated it and it works a treat!
thanks again for quick reply. This website is top notch.
Andy
Re: Hotpoint wd420G flashing lights
the lights are from the top down:1,2 and 4 . Thanks very much for the exextremely quick reply
Re: hotpoint wd420 probs
I can’t find a filter in the hoses that go to the drain pump. Is there one anywhere else?
Re: hotpoint wd420 probs
It’s the valve stem that sits inside the solenoid with the orange electrical connector. I presume this is the rinse solenoid? I think I might need a new valve set
Re: hotpoint wd420 probs
Took off pump and can’t find a blockage. However, I’ve found a slow leak on one of the solenoids at the water inlet point that’s been dripping onto the drain pump. Would this have the same effect regarding the fault code?
Re: hotpoint wd420 washer drier flashing lights!
That sorted it . I found a hair bobble trapped in the impeller of the drain pump.
