aquaff

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • November 4, 2013 at 9:11 pm in reply to: Whirlpool aquasteam 9759 #403141
    aquaff
    Participant

    Re: Whirlpool aquasteam 9759

    The problem was a rubber grommet for the ntc sensor. All fiex . 2 washes later the washer stopped mid cycle with the display flashing. Switched off the machine. Still the same. Had to drain the water from the drum. Now it powers on now and again.Any ideas why the display is flashing ???

    October 22, 2013 at 9:43 am in reply to: Whirlpool aquasteam 9759 #403140
    aquaff
    Participant

    Re: Whirlpool aquasteam 9759

    I have found out where the water is leaking from. Its behind the concrete balance block on the front of the washer.

    August 31, 2013 at 5:31 pm in reply to: Whirlpool AWOE 9558 problem – help! #399817
    aquaff
    Participant

    Re: Whirlpool AWOE 9558 problem – help!

    Ive looked at all of the resistors on the pcb none of them look like they are blown. no signs of burning or discolouration.

    August 27, 2013 at 8:36 pm in reply to: Whirlpool AWOE 9558 problem – help! #399815
    aquaff
    Participant

    Re: Whirlpool AWOE 9558 problem – help!

    Hi ive the same problem but my wadhing machine is the whirlpool awoe8558. Ive traced the power to the program unit. But still no joy. Any help appreciated.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)