[Auldyn]

Re: Whirlpool Washer/Drier AWG349/4

Cheers Chris
Fault indicates door interlock but it seems to be ok will run the test sequence on it to see if it shows anything else.

[Auldyn]

Re: Maytag spares

Many thanks managed to get a blower for the drier from JLA in Ripponden Yorkshire they seem to have a good stock of Maytag spares

Cheers

Paul

[Auldyn]

Re: Dishwasher Whirlpool ADG7560/1

Thanks help on this
I have run the test sequence as everyting else seems OK the fault must be a faulty control module, Initial fault was just the wash pump motor.
The cost of the motor + the control module is now taking the machine towards the region of an uneconomic repair.
Paul

[Auldyn]

Re: Dishwasher Whirlpool ADG7560/1

Numbers as requested
8511 757 15810
Ser No 33 0730 003327
hope this helps
Been over everything checked all contacts from sensors back to the control board same fault over and over again

I have the test sequence for ADG957 but this one uses a different control module although menu on control panel is roughly the same.

cheers

Paul

[Auldyn]

Re: Dishwasher Whirlpool ADG7560/1

Hi
This machine has no optical water sensor only a paddle wheel with a reed switch at the bottom of the matrix that is pulsing on and off when the meter is connected.
I dont have the test sequence for this dishwasher so can’t decipher the bleep codes, it only has a start led and an led for each program no fault display.
hope this helps
Paul

[Auldyn]

Re: Dishwasher Whirlpool ADG7560/1

Hi
NTC sensor is in the sump at the front of the machine tested that and it seems OK cold 148K hot 12k that seems the same as a new one.

Taken off the matrix its very clean cleaned all the contacts on the connector to the flow meter made sure the contacts are touching the board and tested for continuity up to control module, it’s switching OK tested it with a meter.

Machine fills pump starts then stops, it fills a small amount again and continues to start and stop 6 times then empties bleeper sounds 3 short then 1 long bleep.

dont know if that is the fault indication?
I dont have the test sequence for this machine

Thanks
Paul

[Auldyn]

Re: GDA Dishwasher fault

Thanks
Faulty microswitch on diverter have replaced microswitch only works fine

[Auldyn]

Re: Hotpoint Ultima 1200 WM75 E15 Fault!!

problem solved heater open circuit

[Auldyn]

Re: Servis Washer / Drier Circuit Diagram

Hi
Simon46
Thanks for that tip it was the Half Load button, don’t get many Servis machines over here on the Isle of Man the white goods retailers don’t sell them, most of the ones I come across are purchased via mail order.
This particular one had been messed around with stats disconnected etc and my suspicion was that some of the timer wires had been switched.

[Auldyn]

Hi kwatt
I just assumed this was the trade side “Trade Technical Enquiries”
This is my first post since joining in August.
Paul Cringle, Auldyn Electrics.

[Author]

Posts