[bancro]

Re: Ice Build-up on base of freezer

Thanks for your replyTony, do I have to remove the plastic back panel in the freezer or can I access from the rear of the appliance to clear the blockage ?

[bancro]

Re: BEKO WMB 10W Door Seal Replacement

Thanks K. ……..I’ve told my daughter it will probably be best to buy a new one!!!!!!! I’ve done bearings once before on a Hoover 1100 but I had access to a Toolrroom workshop where I used to work and the toolmakers were very helpful. I think I’ll give it a miss this time.

Thanks again.
Bancro

[bancro]

Re: BEKO WMB 10W Door Seal Replacement

🙂 I managed to get the spring back on OK with the help of an extra pair of hands………but 🙁 ……I think I’ve just found out why the seal came off!
When a wash was put on there was a lot of vibration and a banging noise while spinning, I think the drum bearings are worn, there is a lot of ‘play’ on the drum. Can these be changed ‘in situ’ or does the whole drum have to be removed???
Your advice would be appreciated again.

[bancro]

Re: BEKO WMB 10W Door Seal Replacement

Thanks ‘Penguin’ for the prompt reply…..I hadn’t taken the panel off 😳 and I was on my own 😕 . I’ll try that tomorrow.
Thanks again.

[Author]

Posts