Forum Replies Created
-
Posts
-
Re: Hotpoint WMT02 runs for 1 min, pause with Prog End flas
Well, I managed to get this fixed and working properly. I had also noticed that the conditioner was not being flushed into the drum. Conditioner is only flushed when both cold water valves open together. After a thorough clean of the whole soap tray system and pipes it was still no better. I figured one of the valves may not be opening so ordered a new 2-valve set. Fitted that, no change. Eventually decided it was the control board not sending power to open the valve.
Picked up a second hand control board from e-bay. Not exactly the same one as it was from a WMT01, but no issue. Fitted it in 10 minutes and ran a cycle. No problems. Have since tried half a dozen washes over the weekend. All worked fine and also correctly flushed the conditioner. Missus now very happy, result.
Re: Hotpoint WMT02 runs for 1 min, pause with Prog End flas
I’ve a bit more to add. This now is happening also on another program, E, 40° full wash. After pushing the start button to get the machine to carry on it’s cycle, it then runs OK and completes the cycle, but the PROG END light stays on continuously through the cycle. Not sure if that helps!
I have a new, genuine, heater element for this. If there’s a possibility that this could be causing the symptoms, I’ll fit it. Opinions?
