Forum Replies Created
-
AuthorPosts
-
October 27, 2015 at 4:49 pm in reply to: fridge – strange problem. Ice inside but fridge is 12deg? #430542
blazerfrazer
ParticipantRe: fridge – strange problem. Ice inside but fridge is 12deg
Hi again, i have put a new cheap thermostat in and its the same, i did some experimenting… there is a tube to push the tail of the thermostat down that leads in the direction of the back, it starts at the front where the stst is located and runs inside just below the surface.When its pushed all the way in the fridge will only go down to 12 but as i pull it slowly out ( testing over several hours) the temp drops down. if i remove the tail from the tube completely and have the tail just hanging inside the fridge, the fridge runs continuously and the temp drops down to -1. so full in 12deg, full out -1 and this is on both stats, new and old. any ideas? thanks Frazer
June 20, 2015 at 7:33 pm in reply to: Beko DL1254 low pump pressure hot but high pressure cold #428338blazerfrazer
ParticipantRe: Beko DL1254 low pump pressure hot but high pressure cold
an update, in case anyone had the same problem as me. DOH! Seamy was correct, it was too much suds, the previous owner had filled the rinse aid with washing up liquid and when i first run it on the hot wash there was the remnants of the old tablet in the system + my new tablet, all added up to a foam out! after 3 flushes with no tablet and cleaned rinse aid pot, i was able to do a hot wash with one new tablet with no problems, hope this might help someone.
June 20, 2015 at 1:32 pm in reply to: Beko DL1254 low pump pressure hot but high pressure cold #428337blazerfrazer
ParticipantRe: Beko DL1254 low pump pressure hot but high pressure cold
Hi, its 18 months old. I was given it today and i have been testing it with the hope to fix it and replace our smaller one. Our family is growing and so is the usage of crockery! original owner reported no pump at all but he is not technical. interestingly this test next run is at 50deg with no detergent and its working fine at the mo, first wash was 70 with detergent when the pump flow reduced and i posted here, and yes it looked really foamy. ill post back after this 50deg no detergent wash has finished, thanks SDeamy
-
AuthorPosts
