Forum Replies Created
-
Posts
-
Re: AEG L14710 mains power but no display
Check your power supply first. The power light on the machine can illuminate even if there is a faulty socket outlet, just plug a radio or table lamp or suchlike in to confirm it definitely works. If it does then I would contact an engineer as it’s likely to be a pcb failure which may have been caused by failure of another component.
Re: Electrolux Washer Dryer Prod No. 91460600(01)
Bazza500 is right, dryer elements go down to earth on these, you’ll usually get ed4 error code.
Re: BEKO BC73F FRIDGE OVER FREEZING
Sounds like sensor failure. I think they are foamed in on these.
Re: Drum lifters
I’ve had a few of these where the original paddles had broken off. I found that you can simply use the tabs on the drum and not bother with the fixing screw.
Re: AEG Washing machine 914510109-02 Diagnostic?
What you have to do with this one is hold down the two buttons while pressing the on switch and then immediately turn the dial one move to the right while still holding the two buttons, before the display lights up.
Hope this helps mate.
Re: electrolux ZT695 91184702000 (D/W)
If your changing it because it’s not filling, there is a service kit for this type mind (Part no 5027 86 59-00/3) which means you don’t have to change the IWMS.
If you do need to change it, it’s a pretty straight forward job. Take off lid, side panel, front panel under door. Disconnect inlet hose and inlet valve cover. Remove the large plastic nut holding the IWMS into the tank cavity.
Remove side tank screws and the IWMS will just pull off. Disconnect valve/hoses from bottom of tank.
Re-fit new IWMS and away you go.
