Forum Replies Created
-
Posts
-
penguin45
Its BRINELLING named after the brinell hardness test ,put false brinelling on web search and educate yourself on tribology.I can’t divulge any more info it might be harmful.
Anyway the wife has got me on the dishwasher now ,has anybody got a wiring diagram as i have misplaced a couple of wires and the machine is now licking the plates clean.come down off yor horses ,you all know as well as i do that 95 {e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of the wiring is push on connectors that will only fit one way.The only problem i had was the two spade connections on the pressure switch and the control board.once i found the colour codes it was done in seconds .time yourself and see how long it take to push on four spade connection’s. Just for good measure I even put the machine onto test mode ,to test the components,(I bet you do that don’t you ?????) Not bad for a beginner ,I am pretty sure the bearing’s will last as I made a rig up and pressed them in on the outer race ,after all I didn,t want to cause any brinneling to the bearing,s before it had even run.Cheers
Re: HOTPOINT WMT03P WASHING MACHINE WIRING DIAGRAM
hi workman
i am going to try a few things check the voltage on the wires,I believe i may have sorted the problem,but please keep in touch.I should have taken a picture of the wires but i had other things on my mind. Just for info it is the two wires entering the back of the control board .there are two wires onto the pressure sensor which detects the water level and the two wires which go on to the heating coil. i also have a problem with the wires which control the water inlet solenoids .i will deal with one at a time .As I said the engineer would spend 30 seconds ,the machine is fully rebuilt like New .Complete stripdown, New Bearings ,descaled and reassembled .Most engineers just change the drum as it is a lot easier.
Cheers 😀
