Forum Replies Created
-
Posts
-
Re: Neff Dishwsher Spray Arms not rotating
Morning
I ran the test as suggested and cleaned out the upper and ower arms. Unfortunately it did not make any improvement.
However, what I did notice was that when the spray arms were off and with the machine started, when I opened the door during the cycle the water was being pumped through the inlet at the bottom of the machine. Would this indicate that the motor is working as expected?
I have noticed that there is a lot of up and down movement in the lower spray arm when I put it back and wondered if it was worn, thus allowing the pressurised water to leak before it gets into the lower spray arms and the pipe work to the upper arm. ❓Should there be any play in the dpray arms, and I coud not see any evidence of washers or seals, is this standard?
Many thanks 😀
Clivers
Re: smeg A2 element replacement
I’ve ordered the part, (very helpful chap on the phone thank you), I’ll take a look at the forums for help. Thanks again, what a great service!! 😀
Re: smeg A2 element replacement
Morning Dave, will the spare part come with installation instructions, or can you point me in the right direction ❓
Re: smeg A2 element replacement
excellent, could you tell which replacement option is easiet, inside or from the rear? 😀
Re: smeg A2 element replacement
thanks Dave, do you know where i could get one of these elements from as the cooker is being removed for a new floor to be layed and I’ll have the opportunity to replace it while it’s disconnected from the mains!!! 🙂
Re: Smeg A2 burners
Thanks for the quick response. The thermocouplers have been cleaned, but unfortuantely have made no difference. Time to book an engineer I think. The repairs@ link does not cover my area, (New Malden, Surrey) do you have any approved service engineers i could contact?
many thanks
clivers
