[corimaman]

Hi andyjawa

i did order a replacement and fitted quite easily and guess what: it’s failed! You were absolutely right. RCD tripped, reset, tripped…. before realising it was my £109 replacement. So I’m now thinking I need to get a new washer but want one that does not have one of these dreadful heater pumps. From your experience is there any washer out there with a different heating/pumping system that might be more reliable?

[corimaman]

Great, thanks for the advice and the link to the product. I’ll get one on order.

[corimaman]

Re: Zanussi ZWG1120M – E62 code

Hi – thanks for your advice but going back to the symptoms how does an overheating problem cause the motor to be intermittent? I know E62 is the code for overheating but could Zanussi have changed this?

[corimaman]

Re: Zanussi ZWG1120M – E62 code

Hi Specialist01260 – thanks for your reply, are you able to direct me to the suspect thermistor and when you say it could be the control board, is that a case of replacing the whole board, the one on the back of the control fascia?

[corimaman]

Re: Aqualux EW 1200 washer dryer -no rinse or cold wash prog

Okay so I have pulled the connectors off and tested across the contacts. The green coil is open circuit and the white coil is near what you said at 4.1k so it is safe to say that the green coil is faulty. However how does the solenoid unit come away from the back of the dispenser compartment? The hose and jubilee clip on the bottom way is not a problem although out of interest what does this feed? Thanks for the pointers so far.

[Author]

Posts