CR

Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • in reply to: Smeg DWI612C #391989
    CR
    Participant

    Re: Smeg DWI612C

    Ok, thanks for the reply

    in reply to: Smeg DWI612C #391987
    CR
    Participant

    Re: Smeg DWI612C

    Thanks for the quick reply electrofix (and for my other post on the Smeg oven!)

    Just to check, is it the PCB itself or a separate component?

    If its the PCB I was going to see if QER can repair it (~£75) and replace it myself, rather than the £150+ or so for a new one

    Thanks

    in reply to: Smeg DWI612C #391985
    CR
    Participant

    Re: Smeg DWI612C

    Hi, I’m getting the same fault as the OP and have tried resetting etc.

    The only difference is that I’m able to get a full cycle for the intensive wash (though not sure how long that will last as the fault has got progressively worse on the other washes!)

    Were there any answers to this fault?

    Thanks

    in reply to: Ariston Fridge Freezer MBA 3831V no longer freezing #261584
    CR
    Participant

    Re: Ariston Fridge Freezer MBA 3831V no longer freezing

    Thanks for the reply.

    Finally got it going, the freezer dial had actually broken, so while it seemed to turn it didn’t actually do anything. Pulled it out and used a screwdriver to turn the recessed dial to off and left it for a while.

    This seemed to work when I turned it back on!

    in reply to: Ariston ALD10 Washer Dryer – No power / functions #242153
    CR
    Participant

    Re: Ariston ALD10 Washer Dryer – No power / functions

    Thanks for the reply

    One of your recommended engineers went round today. The motor had shorted and burnt out the PCB, he estimated it would cost £280 – 300 to repair.

    So a new machine then and definately not an Ariston!

    in reply to: Ariston Margherita 2000 – I also have a problem! #112948
    CR
    Participant

    Ariston Margherita 2000 Washer Dryer
    Mod ALD10

    Trying to fix for a friend. Previously it delayed starting for no reason and later had to be switched off to stop spinning. Now no power and no functions, I’ve had a quick ‘poke’ around inside and found no obvious problems like loose / burnt wires etc (not sure were the fuse may be) except I found a broken rubber belt 5mm diameter in section and 180mm diameter overall at the back end of the machine at the bottom ❗

    Any advice would be great

Viewing 6 posts - 1 through 6 (of 6 total)