[criss5555]

Re: 10 flash fault

Hi again, took the pressure switch off blew into it and could here the switch clicking, the pipe to it is clear. Put it all back and switched on the pump runs, dials clicking round and still the code 10 fault, would it be worth buying a pressure switch to see if that cures it. Thanks Chris

[criss5555]

Re: 10 flash fault

Hi, I replaced the pcb 7 months ago so I hope its not that again. I’ll have a look at the pressure switch tomorrow (Sun) and let you know how I get on, Thanks for info, Regards Chris

[criss5555]

Hi, Tony at EMW sorted the board out and machine is now up and running. Thanks for all your help I could not have fixed it without you and this wonderfull site. Best regards, Chris

[criss5555]

Hi, thanks for that lead I’ll give them a ring tomorrow and hopefully they’ll be able to sort things out. All thats on the box is a sicker saying module no eeprom. Thanks again I’ll let you know how I get on. Cheers Chris

[criss5555]

Hi, No they did’nt tell me I needed to programe the board. I notice this site does not sell an eprom, I can buy one from the ariston site for 33.99. Can you give me any advice about what to do once I’ve got it. I’m a retired engineer but electrics was never my strong point, changing a board with a few plugs and hey presto seemed the easy option, I am now determined to fix this bl****** machine if it’s the last thing I do. Thanks for your help to date. Regards Chris

[criss5555]

Re: Ariston AWD12

Hi, I bought it online from the ariston parts site. unfortunatly. I had’nt found your site at the time. Hope this does’nt disqualify me from receiving help. The machine is about 5 years old but has had little use as it is fitted in a american motorhome. I would not bother and buy a new one but to get it out means removing a window ect. quite a big job and I’d need about four strong men. Hope to hear from you again. Thanks Chris

[criss5555]

Re: Ariston AWD12

Hi again, I checked all conections to module board and I’m pretty sure there OK but the problem remains the same. If I set the dial to the reset dot I get a slow flashing light then after about 10 seconds it starts to fill with water and at the same time the pump starts to empty the water, then the dial begins to click round with the 3 flash code. Is there any other thing I could check or replace. Thanks again, Chris

[criss5555]

Re: Ariston AWD12

Hi, sorry about threads its my first time and I put the first one in the wrong forum. Thanks for your help I’ll give it a go. Cheers Chris

[Author]

Posts