[ddirect]

Re: baumstic door seal

cheers loaf

[ddirect]

Re: ADG 450 Dishwasher

cheers Dave thanks for the link.

[ddirect]

Re: hotpoint wf000

i know the motor is ok and i know its a board fault,what i want t know is has anyone had this problem and repaired the board themselve or is it a job for someone who refurbishes boards. all the same thanks for the reply

[ddirect]

Re: zanussi FJDR 1666W

turns out this one is a board fault cab, heater ok, purchased new board and configured it machine is now ok. you where right about being related to heater though,presume heater relay on board may have been at fault.

[ddirect]

Re: zanussi FJDR 1666W

thankyou Cab. will give it an insulation test, if your right which i am sure you are, there must be only a slight amount of earth leakage as it does not trip rcd. thankyou.

[ddirect]

Re: smeg wm63141bk

thanks for the reply Eastlmark, but if it is just a hose why is it so elaborate. your reasoning is right was going to do the same thing myself. would still like to understand the whys an wherefores of such a hose. sorry to be a pain
Darren

[ddirect]

Re: proline washpump

thanks for the info Mike. and Chris i now your probably right lets hope it dont bite me in the backside,
cheers hyg-dip for the number.

[ddirect]

Re: diplomat oven fan

cheers Chris will do that on monday.
Darren

[ddirect]

Re: hotpoint pcb repair

cheers martin

[ddirect]

Re: Parts wanted

will try and sort pic out presume you mean pump

[ddirect]

Re: Beko wm1512w

thankyou for the reply Jazzmeister will go for timer

[ddirect]

Re: Hotpoint WF740

cheers electrofix just been reading same thread myself looks like the way to go

[ddirect]

Re: hotpoint C361EW electric cooker

thanks chaps for info, a bit more food for thought, will post back to let you now results,not going back for a while as they going on hols.

[ddirect]

Re: service m6712s

cheers PGS and Martin will pass info on.

[ddirect]

Re: Indesit w123

these machines are a pain to many problems, just been to hotpoint wd420 went through the usuall checks as mentioned above,ordered recon board fitted board same problem, after further investigation and lots of expletives under my breath found broken wire from the ntc where it is secured to the harness at the base of the machine,never had this before so maybe one to look out for in the future. so now is the time to start doing continuity checks on these wonderfull machines,maybe i should have thought of that in the first place. 😯

[Author]

Posts