Forum Replies Created
-
Posts
-
Re: PCB,s
There is a guy locally who collects old WG,s and breaks them for scrap I think I will do a deal on the boards, U/S or not might be an investment
Re: PCB,s
Thanks thats just the info I was after, I have one pcb repairer on file I use although infrequently but I cannot recall the name SRQ or similar perhaps you could suggest others
Thanks again DevlinRe: Commercial fridge thermostat.
Do you mean it has a coiled metal capilary if so I think you need a Ranco VB7 or similar
DevRe: door gasket/seal
Yes ok perhaps my critisisms are ill founded, I shall endevour to be a bit more specific,tolerant, and patient in future.
Devlin MaguireRe: door gasket/seal
Model 12nc and serial number given in original
If I said I had a 2003 Clio 1.2 with a noise from the front wheel would I need to tell you it was a Renault, come on
DevlinRe: door gasket/seal
Right, Open door remove spring clip around gasket and push it into the machine Lid off, soap drawer out,remove facia with its buttons lift up and there is a plastic clip to the right lift off facia and sit it on the machine top remove torx head screw in a hole on facia revealed when drawer removed 2 other screws holds water dispenser to L shaped bracket that runs the width of machine more 4 screws hold the bracket to machine lift onto the machine watch the cable ribbon, remove bottom panel 3 screws, 4 screws hold the front on remove these and the rest is easy,
Apparently no one else on this forum knows this so now you are one of the few who do
Devlin MaguireRe: Electra spin
It will go through a entire cylce heats washes just no spin at all, on a spin only function nowt, but drain pump runs
DevRe: Commercial
Actually commercial work is far more lucrative, for example who has worked on Girbau, Silanos, DC, Nelson, Valetine Lincat to name a few when these go wrong it is NEVER a case of “you,dd be cheaper with a new machine missus” and you walk away with a £25 call out having spent more time on on it than you feel comfortable charging for,As for 3 phase I agree with the safety concerns with single phase if you short summit you get a bang and a MCB trips a phase to phase contact results in a hellava lot more bang and you can easily take out the service fuse,
I am a NICEIC registered electrical contractor so for me the issues are well known ,then there is also the rotational issues
I was more interested in a way of sharing excperience and knowledge as like domestic manufacturers are reluctant to give info but some will gladly send all the info you need and over the years you obtain info that can be shared
Dev
