[disapark]

Re: F&P MW511 wont spin

Hi , i am finding a few machines that will not spin and the problem has been the inner drum needs replacing . There is water sealed in the top ring for balance and it seems it leaks a bit and it affects the balance cheers

[disapark]

Re: smartdrive 509 error code 40 (0010100)

sorry that should read code 40 ( 00101000)

[disapark]

Re: F&P GW509 error 11

great thanks for the help

[disapark]

Re: Smartdrive GW503-K flashing lights

Hi yes sorry tried it last nite but was waiting to long when pressing the buttons and the machine just starts as per normal . just redid it but did the sequence quick and it worked like a dream thanks very much for your help

[disapark]

Re: Smartdrive GW503-K flashing lights

Hi thanks for the reply , not sure i am doing it right ,
1
powered it up pressed regular machine powered up ( as in pushing power button )
pressed advance lights advance as normal , pressed water down to low and
powered of ,no change

2
went into diag , pressed and held regular ( pump starts ) and pressed advance light jumps from water high to rinse and then pushed temp down
low water lights , pushed power
all lights are off machine works but if i unplug it starts flashing again

am i doing it wrong ? any other ideas Thanks

[disapark]

Re: Smartdrive GW503-K flashing lights

Hi , yes with MW and LW display boards same problem . I can cancel the flashing lights by going into diagnostics and turning on the low water led (high water led is on and can’t be turned off), this
stops the flashing lights until i unplug from the wall and then need to go thru the same procedure again ,Thanks

[disapark]

Re: Smartdrive GW503-K flashing lights

Great thanks works like a dream , only problem if i unplug and plug it in again the lights flash again , The high water light stays on with the low is there a way to turn off the high ? is there a way to lock it into memory? or is that the board needing replacing ? i have tried 2 other boards (an Mw and a LW) and both give the same error Thanks

[disapark]

Re: F&P Smart Drive error 86

Hi , yes thanks had a serious brain fade 😉

[disapark]

Re: MW059 drain problem code 208

Hi , please if anyone can help with this problem,
what i am getting now is as i plug the machine in i get 01101000 ,the 3 light flash , can’t get into diagnostics , if i push any button it just carries on beeping thanks

[disapark]

Re: MW059 drain problem code 208

Hi thanks for the reply , what i am getting now is as i plug the machine in i get 01101000 ,the 3 light flash , can’t get into diagnostics , if i push any button it just carries on beeping thanks

[Author]

Posts