Forum Replies Created
-
Posts
-
Re: Diplomat AWM8513 pulses?
Thanx guys,the m/c seems to pump ok no pulsing only on fill & on both valves very odd :rolls:
Re: T/Bendix WDR 1041 stops.
I’ll check that but its showing no error codes at all! Now customer says she carn’t start the m/c at all.Oh well back i go. 🙁
Re: South Pacific BBC2
TV makers are always doing this,playing good music but not telling what or who it is,i think the i phone has a programme on it called “shazam” the idea been you put the phone near the music source & then as if by magic it recognises it via its vast data base on line. That aside it was a terrific programme plus the prog that followed about the origins of human life (Title eludes me at the mo’),good nite for telly :tup:
Re: trc cooker model 1657a
Any use? http://www.ukwhitegoods.co.uk/modules.p … ic&t=13199
Re: Hotpoint wm62 spinning problems
I’d check the tacho magnet first,they sometimes crack or loosen on the shaft.
Re: Tricity Bendix DH092 leak!
Cheers for that ,I’ll take a look,i know the seals are ok ,its not very old either but its in such an awkward place ..
Re: Anybody know anything about Kenwood chefs?
Thanx Nige ,already tried that method but it doesn’t make any difference. I carn’t figure out how the new pcb works cos it doesn’t have the moving arm on it that seems to touch the armature end .
Re: Bosch WAE24260GB/01
Cheers guys,hmm didn’t know about the Bosch page,don’t really do much Bosch stuff,this is a favour for a mate. Thanx again…
Re: Indesit WIDL146
I’d be tempted to put a hose on it then route it out of the m/c & either point the hose down or up so as to let the steam flow out, bit like a vent hose on a car/bike engine from the coolant reservoir!
