[Ellis]

Re: WM-1465FHD Again!

Thanks, which hoses will they be? Sorry, theres not much I can see apart from the black hose, do you mean round the back??

😕

Thanks for your reply! 🙂

[Ellis]

Re: WM-1465FHD Again!

It just stopped in the middle of a full wash with a ‘stuck’ kind of noise.

All I did was turn the filter so some water escaped and water seemed to gush through and the spin continued…

I checked the spindle behind the filter and that seemed to be spinning without obstruction, could it still be the problem do you think…?

[Ellis]

Re: WM-1465FHD

Thankyou very much.

There was a small part of a dog bone jamming the fan, this removed – everything A=OK!

Many thanks again 😀 😀 😀 😀 🙂 🙂 🙂 🙂 🙂

[Ellis]

Re: WM-1465FHD

Penguin45 wrote:You’re on the right lines – no drain detected within time allowed. The filter is about 2″ in diameter, and unscrews anticlockwise. Hands, knees and torch, check right back into the pump chamber, make sure that the impellor “pings” round freely.

If you can set spin only, check that the pump is turning before replacing filter. If the machine is coupled to a sink spigot (wrong, but people do it), check that as well.
.

Thanks,

I have took the filter out and run a spin and the green spindle is not moving behind the filter housing during the spin, should this be moving?

[Ellis]

Re: WM-1465FHD

The OE is flashing and Im not sure whether that is the filter?! that I emptied, it was a screw out ‘cork’ at the bottom left of the washer behind a removable flap!?

Sorry forgot to add that!

[Author]

Posts