Forum Replies Created
-
Posts
-
Re: Indesit di620 decided to throw its hand in / spit dummy
Thanks Martin
I suspected this as they dont have a great pedigree!!
Soit looks like Ill bite the bullet and get a new pcb. Ill look up the serial number and refer to previous posts which one I require thanks
FarghiRe: Indesit di620 decided to throw its hand in / spit dummy
Good Afternoon Eminent Technicians
I hope I didn’t offend anyone by addressing you as Gentlemen and Ladies, I was trying to be pc and inclusive !
So as above does anyone have any ideas re above
Many Thanks
FarghiRe: Zanussi Washer stops mid cycle error code 41 (Door ?)
Hi Iadom
It seems as if I have got off on the wrong foot with your goodself. I am really p’eed off withthis machine and if i sounded abrupt or offensive then I take it back re me asking for a second opinion. I know the code E41 gives the started faults but me in my humble way thought there could be more to this error code malarkey than meets the eye. I too am from old Lancashire -St Helens and understand straight talking. So if the door lock is replaced and the insulation is OK then the PCB is playing up right ? This part is approx £160 so the machine is BER. What goes wrong with these pcb’s is it in built obsolecence? Just rantin’ sorry.
PS The door remains locked after stopping mid cycle! 😐Re: Zanussi Washer stops mid cycle error code 41 (Door ?)
Thanks for the reply yes I am aware the error code 41 is door lock/ wiring / pcb fault. I was just wondering why the machine will run a rinse/spin cycle when full of water but wont do this mid wash rinse/spin cycle. Logic dictates to me that if the door lock was at fault then the machine would not rinse / spin when that particular program is chosen!
As to using a megger I did say I could use test meter – a megger is out of my range both financially and knowledge – wise
