fixitok

Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • in reply to: Zanusssi Aquacycle 1000 SPIN PROBLEM #433994
    fixitok
    Participant

    Re: Zanusssi Aquacycle 1000 SPIN PROBLEM

    Dave, thanks for diagnosis, yes it has the rotary control to select programmes etc.
    Any data on power supply-voltage etc & I would check with meter.

    Reg Pat

    in reply to: nordMende washing machine #422989
    fixitok
    Participant

    Re: nordMende washing machine

    1. Purchased machine from local retailer
    2. September 2011 (estimate)
    3. I live in Co Mayo, Ireland
    4. I filled in the “request support” facility on their website,http://www.nordmende.ie received automated acknowledgment…………..
    Do you represent nordMende?

    in reply to: nordMende washing machine #422987
    fixitok
    Participant

    Re: nordMende washing machine

    Seamy
    I emailed nordMende when my washing machine needed drum bearings. Got an automated reply stating customer service would contact me. Nothing heard since.
    Rang suppliers of the washing machine, they told me they no longer stock
    norMende (wonder why?) & they were unable to recommend a service man
    Good Luck

    in reply to: nordMende washing machine #422984
    fixitok
    Participant

    Re: nordMende washing machine

    I shall recommend Darwin’s quote to nordMende as their mission statement

    in reply to: nordMende washing machine #422982
    fixitok
    Participant

    Re: nordMende washing machine

    You are right about flashing lights, slight leak from bottom of drum made its way
    to heating element terminals, after drying & checking all electrical connections
    normal service restored – fingers crossed.
    Talked to a local serviceman, not very helpful, he says I will be lucky to get 3 months from drum repair.
    Could be sour grapes, knowledge share on the web has affected their income??

    in reply to: nordMende washing machine #422980
    fixitok
    Participant

    Re: nordMende washing machine

    Thanks for advice, replaced drum bearings & seal, used “FAG” bearings 6204Z, 6203Z, SEAL 25X47X10 from motor factors.
    Ran ok for 2 washes, developed intermittent flashing lights & program not finishing?
    nordMende have ignored my emails, should be rebranded “needMending”

Viewing 6 posts - 1 through 6 (of 6 total)