Forum Replies Created
-
Posts
-
Re: Buying a second hand compact dishwasher
Hi
You can “twin” the cold using a Y piece affair.
These are available from most appliance or DIY stores.
HTHGreg
Re: New web site ?
Its a bit cheeky though IMHO, trying to poach. 😯
What did you put Jim if you don’t mind me asking?Greg
Re: Free Training from Proctor & Gamble
Martin wrote:Besides however long each of us have been in this business we are constantly learning from it, I’m sure you will agree?
Well said that man 😉 never the same day twice.
Its also amazing how little the public know hence the need for these lectures/visits so we can pass this knowledge on 😉 .
9 out of 10 of the visits I do, customer doesn’t realise that you need at least two different powders 😯“I generally buy the biggest and cheapest box of powder and bung em all in……. bleach? what bleach”
So thank heavens for the training given freely, past and present 😀
Greg
Re: Bosch D/W: Door handle snapped
Hi
056480 – White handle
056489 – Brown handleThats what the bible says 😉
Greg
Re: KGU3201GB/01 Freezer Staying At -14?
Hi
All drawers out, back sort of locks in on a few nibs. They are a pain and you may break a few, can’t be helped, just take your time.Greg
Re: need help on a neff condenser drier. water tank light on
Hi
I would again remove r/h panel remove and clean uplift pump assembly inc impeller, making sure that uplift hose to top of bottle filter is clear also.
Basically the water isn’t being uplifted causing the water to rise in uplift pump chamber thus activating float unit.Greg
Re: INVISIBLE MAN
Hi
Its megan1 but there is nothing sinister or untoward 😀
Sometimes the server mucks about with logons and offs 😆Greg
Re: KGU3201GB/01 Freezer Staying At -14?
Hi
I think you will find if you give it the 24hr off time and follow the following, that the fault may not re-occur. – Put towels on freezer floor and floor and remove the rear of the inner freezer rear to gain access to the evaporator. Locate the drain channel hole (centre of drain trough) and proceed to “rod” gently with something suitable whilst observing the rear exit of said drain above compressor bath, making sure all if any foreign debris is removed
Leave the power off to appliance whilst undertaking this task 😉Greg
Re: wta2000 not spinning
Still the same request aswell from the link above :rolls:
gegsy wrote:Hi
Full model number aswell please – WTA2000GB/01 or WTA2000GB/17.Greg
Re: Bosch wfo285gb/01
Hi
Had one last week same symtoms as OP, found brushes low.
New brushes fitted and com cleaned with stick and residual carbon dust removed.They wouldn’t seat after numerous unloaded spins and also noticed it pulsing the fill valve at the same time as the spin attempts.
Appliance was in laundry room so customer wasn’t aware that it had been arcing for weeks and causing irrepairable damage to the motor commutator and/or module 😥Greg
Re: Bosch WFT 8030
Hi
I think I have deciphered the code 😀 if I have its saying you have a pump or drain fault, which would tie in nicely with the excessive water in the drum 😉
You could try draining appliance down via its small discharge pipe near drain pump filter, once drum is empty remove filter completely and inspect inside for blockage/debris etc in and around the impeller.Un plug appliance before attempting this :plug:
Greg
