Forum Replies Created
-
Posts
-
Re: Bosch WFP 3300 Problem
You must have low water pressure ,kinked fill hose or blocked strainers as computer board is timing out as fill is taking longer than 4 minutes.
You should just be able to select drain or spin to empty water 😕Greg
Re: Bosch dishwasher SGS45E02GB/45
It gets em to a nice workable level rather than struggling at ground zero 😉
Greg
Re: Bosch dishwasher SGS45E02GB/45
Hi
Yea OT its not too bad.
You will need to (ideally workmate) put it on its back and remove base to gain full access.
Although a few hot washes usually flushes the crud out of most areas 😉 only need access if you need to change pcb (never had a faulty one in 10 years)Greg
Re: Bosch dishwasher SGS45E02GB/45
Hi OT
Its on the instantaneous water heater manfold which connects to the sump area.
That is what I meant to say in previous post (blonde moment, ‘cept Im a bit sparce in the hair area 😀 )Greg
Re: Bosch dishwasher SGS45E02GB/45
The problem may lie internally though, where the beam shines through the translucent housing, it may have some crud impeding the beam.
May need a good rodding, ooer 😆Greg
Re: Bosch dishwasher SGS45E02GB/45
Hi OT
The “C” shaped pcb is on the sump and will pull out. Its just got one infra red tx LED and one rx LED, thats it. You can’t miss it 😉Greg
Re: Holes in clothes
Hi
Zips,foreign objects and some cheap detergents are all suspects.
What make and model do you have ??Greg
