[gegsy]

Re: How to defrost Proline PC226A, user manual would be usef

A nice job there for you Clyde 😉 😆

Greg

[gegsy]

Re: Smelly Ice

Older type Whirlpool advised to reduce that vent diameter by grommet and silicon.

Greg

[gegsy]

Re: help i need a user manual for ariston LSV66 UK1

Ok Sulu 😉
You could try Ariston on 08709 077 077 or handbooks@indesitcompany.com

Greg

[gegsy]

Re: Ariston FV271GB – Manual & Element Fitting Question

You could try Ariston on 08709 077 077 or handbooks@indesitcompany.com

Greg

[gegsy]

Re: Indesit DI67 Not Taking the tablet

Hi Clyde :waving:

Greg

[gegsy]

Re: Indesit DI67 Not Taking the tablet

I think you are on a winner there :tup:

Greg

[gegsy]

Re: Ariston FV271GB – Manual & Element Fitting Question

Hi Handy
This is what you need http://tinyurl.com/oarrb
Power off before attempting any repair :plug:

Greg

[gegsy]

Re: Indesit DI67 Not Taking the tablet

chojin wrote:Is the tablet door supposed to open during the cycle?

Yes during any of the wash cycles not the pre rinse.

When it has filled and you hear the wash start, if you open the door quickly, do you get a spray out of the cavity and can the spray arms be seen to slow down and stop??

Greg

[gegsy]

Re: How to defrost Proline PC226A, user manual would be usef

Nice find and advice Clyde 😉

Greg

[gegsy]

Re: Module repair – handy triacs

Excellent tip , nice one Andy.

Greg

[gegsy]

Re: Anguis in herba

Is it a full fucking moon

Maaartahn wrote:Hi,
I’m new here, so if I’ve posted in the wrong part of the site or a post similar to this one has already been posted, then please excuse me.
Moving on then, the problem I have is with my Indesit C239 NF UK fridge/freezer, it is relatively minor… I think. Basically when I open the fridge door, the light inside is not on, the food and drink inside is still cold.
I thought that perhaps it could be the light bulb, if so how do I go about removing and changing the lightbulb (also is the lightbulb a special one or can it be bought anywhere?),
Please get back to me asap,
Thanks,
Maaartahn

Greg

[gegsy]

Re: What was…

Goatboy wrote:Ps. Soz I’m not here much lately, but I’m very busy (personally, not vocationally.)

So who’s the lucky man :snigger:

Greg

[gegsy]

Re: Anguis in herba

Ok have posted and removed his post re-

phil59 wrote:if the machine has a seperate circuit board usually low down on the side it cant be see with out takin the back off,if it has it will be faulty i can repair it for you if you want

Total crap post IMO

Greg

[gegsy]

Re: Zanussi FLE 1216 E

Phil59
This is your second post offering advice, if you are in the trade and need access please use the appropriate link.
I have deleted your post as it is-
a/ Poor fault diagnosis,ie your not familiar with appliance yet assume module/pcb to be at fault
b/ Offering a repair service (a big no no) in a post

Regards

Greg

[gegsy]

Re: Anguis in herba

Not a trade member Jim. He may just be offering a goodwill gesture re-repair 😕

Greg

[Author]

Posts